ITech IT6952A - OVP Function; Key Lock Function; Rear Pins Function

Output Commands
Copyright ©ITECH Electronic Co., Ltd. 23
Chapter6 Output Commands
OUTPut
This order is used to open or close the output of power supply. When output is
off, the voltage and current of power supply is 0V/1mA.
Order syntax:
OUTP[:STATe] <bool>
Parameters:
0|1|OFF|ON
Query syntax:
OUTPut?
*RST value:
0|OFF
OUTPut:TIMer
This order is used to set the state of output timer.
Order syntax:
OUTPut:TIMer[:STATe] <bool>
Parameters:
0|1|OFF|ON
Query syntax:
OUTPut:TIMer?
OUTPut:TIMer:DATA
This order is used to set output timer’s time.
Order syntax:
OUTPut:TIMer:DATA <NRf>
Parameters:
0-99999.9
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com