Function and Features
Copyright © Itech Electronics Co., Ltd. 26
“SaveData success! “ for 1 second.
SWEEP SAVE
Save data bank=0
13. Return to Previous Menu and press to exit menu.
SWEEP
Edit Recall Disable
> Recall sweep file
1. Press multiple keys (Shift)+ (Sweep) to menu operation
Off
0.0V 0.0mA 50.0
0.00W PF=0.000 0.0S
2.
Press right arrow key then press key to confirm when
Recall key is shining.
SWEEP
Edit Recall Disable
3. Press numeric key to select needed recall file and press
key to confirm. VFD display “Recall Data success! “ for 1 second.
RECALL SWEEP
Recall Sweep=0
4. Return to Previous Menu and press to exit menu.
SWEEP
Edit Recall Disable
> Set sweep test state and start test
1. Press multiple keys (Shift)+ (Sweep) to menu.
Off
0.0V 0.0mA 50.0
0.00W PF=0.000 0.0S
2. Press right arrow key to “Disable”, press down arrow key and
to infirm when “Disable” is shining. the words”Sweep”
appears at the right bottom,which means the Sweep function is
active.
SWEEP
Edit Recall Disable
3.
Press key to start sweep test. key will shining
during test and will stop after that with power off automatically.
Off
0.0V 0.0mA 50.0
0.00W PF=0.000 Sweep
After the test is finished, to exit Sweep function, you need to change the Sweep
test status to Disable. Operating steps:
1.
Press multiple key (Shift)+ (Sweep) to menu operation.
Off
0.0V 0.0mA 50.0
0.00W PF=0.000 0.0S
2.
Press right arrow key to “Enable”, press down arrow key and
key to confirm and then exit sweep function(Sweep words
will disappeared on lower right of VFD display )
SWEEP
To Next Page
Loading...
