Caution: Do not over tighten this, as doing so could damage the index housing or
the proving cable head.
Note: The Intelis Gas Meter will automatically go into Test Mode (Menu 6) when the
pulse prover output cable is connected.
12. Start the proving test by clicking RUN on the SNAP prover.
13. Verify the LED blinks (pulses) when the air begins to flow through the meter.
08 July 2020 815-0154-00 REV 000 Itron, Inc. Page 30 of 66
Intelis Gas Meter Proving and Setup Guide
4 îProving the Intelis Gas Meter Using the Honeywell SNAP Proving
System
To Next Page
Loading...
Need help?
General
