SAFETY
4 Model 3000 Operation Manual
CAUTION: Portable and mobile RF communications equipment can affect medical electrical equipment.
WARNING: The model 3000 should not be used adjacent to or stacked with other equipment and that if adjacent or
stacked use is necessary, the Model 3000 should be observed to verify normal operation in the configuration in
which it will used.
Accessories
WARNING: The use of accessories other than those specified below may result in increased emissions or decreased
immunity of the equipment.
Part Number Description
590406 Three lead patient cable
590407 Set of three lead wires
590317 Low noise three lead patient cable
590318 Set of three radiotranslucent lead wires
590323 Low noise three lead patient cable with 1kohm resistors.
The minimum amplitude or value patient physiological signal is 0.5 mV (AAMI EC-13 3.2.6.1).
WARNING: The use of the Model 3000 below the following amplitude values may cause inaccurate results:
Minimum amplitude of patient physiological signal
depending upon the type of patient cable.
Patient cable part number
To Next Page
Loading...
Need help?
General
