For Your Safe Flight Page 37
HotSync® your Palm Computer. The EzPalm icon should now appear on
your applications screen.
Memory Data Capture & Import
With the Palm Computer you can
transfer memory data into a file and
then later HotSync the data into your
PC and import it into EzSaveP™.
Here are the steps used to perform
these two operations.
Transferring Recorded Data from the
EDM-700/800 to the Palm Computer
To transfer recorded data to your Palm Computer, proceed as follows:
1. Connect the Palm Computer cradle or travel cable option (available
from Palm Computing) to the JPI Palm Download cable (gray).
Insert the small round plug of the JPI cable into the data connector
on your aircraft instrument panel, and the cradle or travel cable to the
Palm Computer.
2. Simultaneously hold the STEP and LF buttons for five seconds. You
will see the word PROGRAM for two seconds. Tap the STEP button
until you see the question DUMP? N.
3. Tap the LF button once or twice to select either NEW or ALL.
• NEW will transfer only data newly recorded since you last saved
your data.
• ALL will transfer all the data that is in the EDM memory.
In either case, no data will be erased from the EDM.
4. On the Palm Computer, tap the EzPalm icon.
Tap the EzCapture™ button. The Palm Computer will wait a few
seconds for you.
5. On the EDM-700/800, tap the STEP button to begin the transfer
process. The EDM-700/800 display shows the percentage of memory
remaining to be transferred. When this number reaches zero, the
transfer is complete. If you want to terminate the transfer before it is
To Next Page
Loading...
Need help?
General
