For Your Safe Flight Page | 48
3. Set the MP and RPM per your POH to 70 percent power. Let
conditions stabilize.
4. Adjust the HP Constant value PLUS or MINUS so that the %HP
reading on the display equals ‘70 %HP’. Note: this is the percent of
maximum horsepower.
5. Hold both NEXT and Button 2 until you see SET.
Adjusting the MAP
This procedure allows you to adjust the MAP to the altimeter setting at a
sea level airport. NOTE: If airport is not at sea level, use the
correction table on the next page to derive corrected sea level
altimeter setting).
1. Enter the pilot program mode by simultaneously holding the STEP and
LF buttons for five seconds.
2. Tap NEXT repeatedly until you see Lft MAP +0.0. Then hold both the
NEXT and Button 2 until you see ADJUST momentarily.
3. Adjust the value using the PLUS or MINUS until the value equals the
altimeter setting (sea level airport). The adjustment range for the
MAP is ±3.0 inHg.
4. Hold both NEXT and Button 2 until you see SET.
5. Repeat for right engine.
To Next Page
Loading...
