Jackle conMIG 445 - Page 30

conMIG 400/445/545
Operating manual Page 27
DECLARATION OF CONFORMITY
Manufacturer: Jäckle Schweiß- und Schneidtechnik GmbH
Riedweg 4+9
D – 88339 Bad Waldsee
Germany
We declare, that below mentioned current source corresponds to the safety requirements of the
recommendations.
Name of units: Welding power sources for MIG / MAG
Type of units: conMIG 400, 445, 545
Relevant EC recommendations:
EMC – Directive 2004/108/EG ( since 20.07.2007 )
Low voltage Directive 2006/95/EG ( since 16.01.2007 )
Applied harmonized standards:
EN 60 974 – Part 1 Arc welding equipment / Welding power sources
EN 60 974 – Part 2 Arc welding equipment / Liquid cooling systems
EN 60 974 – Part 5 Arc welding equipment / Wire feeders
EN 60 974 – Part 10 EMC product standard for arc welding equipment
Additional information:
Restrictive use, Class A equipment
Jäckle Schweiß- und Schneidtechnik GmbH
Reinhard Jäckle