16
07610-003-62-15-Q
PREVENTATIVE
MAINTENANCE
The manufacturer highly recommends that any maintenance and repairs not specically
discussed in this manual be performed only by QUALIFIED SERVICE PERSONNEL.
Performing maintenance on your dishmachine may void your warranty, lead to larger
problems, or even cause harm to the operator.
By following the operating and cleaning instructions in this manual, you should get the
most efcient results from your machine. As a reminder, here are some steps to take to
ensure that you are using the dishmachine the way it was designed to work:
1. Ensure that the water temperatures match those listed on the machine data plate.
There can be a variety of reasons why your water temperature could be too low.
2. Ensure that all strainers are clean and securely in place before operating the machine.
When cleaning out strainers, do NOT beat them on waste cans. Wipe out strainers
with a rag and rinse under a faucet if necessary. Use a toothpick to dislodge any
stubborn debris.
3. Ensure that all wash and rinse arms are secure in the machine before operating.
4. Ensure that the drain stopper is installed correctly (seated vertically in the center of
the wash sump).
5. Remove as much soil from glasses as possible before loading onto carousel.
6. Do not overll the carousel.
7. Ensure that glasses are placed upside-down on the carousel.
8. Ensure that all chemicals being injected into machine have been veried at the correct
concentrations.
9. Clean out the machine at the end of every workday per the Shutdown and Cleaning
section of this manual.
10. Follow all safety procedures, whether listed in this manual or put forth by local, state,
or national codes/regulations.
PREVENTATIVE MAINTENANCE
MAINTENANCE
To Next Page
Loading...
Need help?
General
