en 92
11 QUALITY OF CUT
11.10 LAYING UNCUT GRASS______________________________________________
NOTE: Arrow indicates direction of travel.
“Laying uncut grass.” This problem is identified by
areas of grass that have been left uncut and laid flat.
Possible Cause Correction
Mowing (ground) speed is too fast.
Cut more frequently, increase HOC.
HOC set close to the actual grass height.
Reduce HOC.
Too much material to clear rear of unit, brought round
the unit pushing over the grass.
Reduce mowing (ground) speed.
Excessive cut grass wrapped on the front of the
cutting blades resulting in blunt blades beating the
grass down.
Cut when grass conditions improve. Remove
excessive grass build up. Sharpen or replace
damaged blades.
Grass always cut in same direction. Cut grass in opposite direction.
TN1234
To Next Page
Loading...
Need help?
General
