7
(OHFWULFDO6SHFL¼FDWLRQV
SAFETY COMES FIRST. WHEN INSTALLING & USING ELECTRICAL
EQUIPMENT, BASIC SAFETY PRECAUTIONS MUST ALWAYS BE FOLLOWED!
1. READ AND FOLLOW ALL INSTRUCTIONS
2.)PIGXVMGEPMRWXEPPEXMSRQYWXFIGSQTPIXIHF]EUYEPM½IHIPIGXVMGMERMREGGSVHERGI[MXLEPP2EXMSREP6IKMSREPERH0SGEP
Codes and Regulations in effect at the time of installation. It is the installer’s responsibility to select the materials ac-
cording to use, carry out the installation correctly, and verify the condition of the network to which the appliance will
be connected, as well as its suitability in ensuring usage safety during maintenance and inspection operations.
3. 8LIFYMPHMRK´WIPIGXVMGEPW]WXIQQYWXFIIUYMTTIH[MXLE%VIWMHYEPGYVVIRXHIZMGIERHERIJ½GMIRXIEVXLMRK
circuit. Make sure that the residual current device is in good working order by pressing the TEST button, which must
trip. When connecting to the mains, we advise installing a multi-pole circuit breaker, which completely disconnects the
appliance in the event of a category III overvoltage; these devices must be positioned in an area that complies with the
safety regulations.
4. Use copper conductors only!
5. The installation of electrical devices and equipment (sockets, switches, etc.) near the Swim Spa must comply with the
legal standards and regulations in the country where the Swimspa is installed.
6. A green colored terminal or a terminal marked “G”, “GR”, “Ground”, or “Grounding” is located inside the supply ter-
minal box or compartment. To reduce the risk of electric shock, this terminal must be connected to the grounding
7. At least two lugs marked “BONDING LUGS” are provided on the external surface or on the inside of the supply
terminal box or compartment.; in particular, ensure that all the metal masses surrounding the hot tub, such as water
pipes, gas pipes, metal boards around the edge, etc., are equipotential.
To Next Page
Loading...
Need help?
General
