26
MARK76J0002 Rev 3
Important Notice:
• Never operate this machine when the ambient room air temperature is greater than 104
degrees Fahrenheit. Never operate this machine when it is not ventilating itself properly
(too hot inside).
• This device may not be used by people with reduced physical, sensory or mental
capabilities or who have insucient epxerience and/or knowledge without supervision. A
person responsible for their safety must make sure, either by supervision or instruction,
tha tthe deivce is used correct and safely. If there is any doubt about the above mentioned
instructions then that person cannot use this device.
• Never operate this machine when it is not ventilating itself properly (too hot inside).
• The salon owner or operator may never, under any circumstances, open the bench or
canopy of tanning units without the supervision of an authorized service person.
CAUTION: Please refer to your individual unit for the recommended exposure schedule and
proper exposure times for the model that you have purchased.
The Electrical requirements for your ProSun unit are:
Model Breaker 1 Volt 1 Breaker 3 Volt 3 Hertz Operating
Amps 1
Operating
Amps 3
ProSun Jade 32J 20 Amp 120V ~ N/A N/A 60 Hz 17 Amp N/A
Connecting a 120v unit to a 220V power source constitutes an automatic NULLIFICATION of
the manufacturers factory warranty, because it could cause damage to the unit’s system.
Please insure that your electrician and/or installer, reads this user’s manual carefully prior
to the installation of your ProSun unit. Service personnel should be authorized by ProSun
to perform work on equipment and should have knowledge of equipment and read the full
manual.
WARNING: Always disconnect the ProSun unit from its power supply when serving or
repairing the unit.
WARNING: Plug is used as a means of isolation.
WARNING!
To Next Page
Loading...
