37
MARK76J0002 Rev 3
Tanning Mode
The following description is for a unit that has all possible features, some of these features
may not be available for your unit or market.
DANGER!
Excessive dose of UV radiation
Excessively prolonged tanning sessions may cause severe
damage to skin and eyes.
• Never operate tanning deivce with a defective timer.
• Observe the tanning times given in the exposure sticker based
on your skin type.
Starting the tanning session
Press start once on the START button on the display. You will see the maximum minute
time, here you will use the minus button to select the desired minutes for your session.
Then press START again to turn on your session. If you do not push a button quickly
enough the display will go blank and you will need to start this process again.
Before enterring the tanning bed prepare yourself for the session.
• Remove all clothes and jewelery
• Remove make-up and cosmetics
• Put on tanning lotions( if applicable)
• Remove glasses, contacts can be worn under goggles.
• Put on protective goggles.
• Close the tanning device
• Lay down in the unit facing up towards the display
• When the session is over do not push up on the acrylic but rather put your hand outside
the unit and push the canopy open.
Operation during the tanning session
During the tanning session the features can be used by pushing the buttons on the control
panel.
You can push the feature you wish to use (i.e. the fan button followed by the increase
button or decrease button.
Note: 20 seconds after your last input the control display screen will go back to the session
time. You can change the features at any time by pushing the button of the feature you wish
to activate.
To Next Page
Loading...
