43
MARK76J0002 Rev 3
A B C D E F
Start
Stand-alone mode:
By depressing start once the “+ and –“ buttons can be used to set the tanning time.
Pressing for a second time will start the unit.
Stop
Stand-alone mode: (for residential units)
Pressing stop once will cause the unit to “pause”. The lights will go out but the
ventilation will continue
to run.
Pressing stop twice will initiate a mandatory after-cooling phase of 3 minutes. The unit
cannot be started during these 3 minutes.
Remote mode: (only for commercial units)
Pressing stop once will cause the unit to “pause”. The lights will go out but the
ventilation will continue
to run.
The unit will not respond to pressing stop several times. The external timer
automatically will switch the unit o. Switching o will initiate a mandatory cool down of
3 minutes. The unit cannot be started during these 3 minutes.
A
B
Illustration after-cooling
Note: Typically Stand-alone mode is for residential use and Remote mode is for commercial use
All units come standard in remote-mode
Operation
To Next Page
Loading...
