Page 3
Table of Contents
Section 1. Important Safety Instructions ........ 4
Section 2. Installation of the User Interface ... 6
2.1 Introduction ......................................................... 6
2.2 The User Interface Panel .................................... 6
2.3 The User Interface Components ......................... 6
2.4 Installation of the Backplate onto an
Electrical Box ...................................................... 6
2.5 Installation of the Backplate on a Flat Wall ......... 7
2.6 Connection to the Jandy ePump
TM
Variable
Speed Pump ....................................................... 7
2.7 Jandy ePump™ Variable Speed Pump Switch
Settings ............................................................... 7
2.8 Connection to Remote Contacts ......................... 8
2.9 Remote Operation .............................................. 8
2.10 Remote Closure 4 Behavior ................................ 8
Section 3. User Operation ................................ 9
3.1 OFF Mode ........................................................... 9
3.2 RUN Mode .......................................................... 9
3.3 Manual Start and Stop ........................................ 9
3.4 Pump Speed Setting ........................................... 9
3.5 Timeclock Setup and Operation........................ 10
Section 4. Service Setup Options ................. 11
4.1 Entering Service Setup ..................................... 11
4.2 Minimum and Maximum Pump Speeds ............ 11
4.3 Load Defaults .................................................... 11
4.4 Last Fault .......................................................... 12
4.5 Priming Speed and Duration ............................. 12
4.6 eStar Speed ...................................................... 12
4.7 Pump Freeze Protect Operation ....................... 12
4.8 Selecting Pump Type ........................................ 13
Section 5. User Set Up Options ..................... 13
5.1 Setting Time-of-Day .......................................... 13
5.2 Labeling Presets ............................................... 13
5.3 General Labels ................................................. 14
5.4 Custom Labels .................................................. 14
5.5 Display Light Control ......................................... 14
5.6 Language Selection .......................................... 14
5.7 Run Duration (Presets 3 and 4 Only) ................ 14
Section 6. Menu Flow Chart ........................... 15
DATE OF INSTALLATION
INSTALLER INFORMATION
INITIAL PRESSURE GAUGE READING (WITH CLEAN FILTER)
PUMP MODEL HORSEPOWER
FILTER MODEL
SERIAL NUMBER
CONTROLLER MODEL SERIAL NUMBER
NOTES:
EQUIPMENT INFORMATION RECORD
To Next Page
Loading...
Need help?
General
