STITCH LENGTH
CORRECT SETTING
The actual stitch length (F) should be 2.8 to 3.0 mm (7/64 to 8/64”) when the stitch length
dial (E) is set at “3”.
TO ADJUST
1. Remove the front panel unit. (Refer to page 10.)
2. Set the stitch length dial (E) at “3” and the differential feed dial (D) at “1.0”.
3. If actual stitch length (F) is longer than 3.0 mm (8/64’), turn the adjust screw (C) to
the direction of A.
If actual stitch length (F) is shorter than 2.8 mm (7/64”), turn the adjust screw (C) to
the direction
B.
4. Attach the front panel unit. (Refer to page 10.)
32
www.promelectroavtomat.ru
To Next Page
Loading...
