BELT TENSION
CORRECT SETTING
To check the belt tension, press the belt in the middle of the span lightly with your finger
(approx. 300g). The belt should depress 5 to 6 mm (13/64” to 15/64”).
TO ADJUST
1. Remove the belt cover (Refer to page 6.)
2. Loosen the 2 set screws (B), then tighten them slightly.
Adjust the belt pressure, then tighten both set screws firmly.
3. Turn the hand wheel a few rotation and check the belt tension again.
4. Attach the belt cover.
34
www.promelectroavtomat.ru
To Next Page
Loading...
