Janome 134D - Service Access; Face Plate Removal and Attachment; Belt Cover Removal and Attachment

FACE PLATE
I. Remove the setscrew (A) to remove the face plate (B).
BELT COVER
TO REMOVE
1. Remove the set screw (C).
2. Open the looper cover (D).
3. Loosen the two set screw (E) and (F).
4. Pull the top end (G) and back end (H) at the same time.
TO ATTACH
5. While inserting the three projections (I, J & K). Push the belt cover (L) against the ma-
chine body.
6. Tighten the three set screws (C, E & F).
7. Close the looper cover (D).
6
www.promelectroavtomat.ru