9
Adjustment of Foot Pressure
It is not necessary to adjust the presser foot
pressure for normal sewing.
When you sew heavy or lightweight fabrics, turn the
adjusting screw:
- clockwise for heavyweight fabric.
- counterclockwise for Iightweight fabric.
* For normal sewing, set the adjusting screw so
that its head comes out above the top of the
machine by 2 mm.
See the illustration.
1
To decrease
2 To increase
3 Adjusting screw
4 Top of the machine
Removing the Presser Foot
[1]Turn off the power switch and unplug the
machine.
[2]Raise the needle and the presser foot.
[3]Press the lever located on the back of the foot
holder. The presser foot will drop off.
1
Needle
2 Presser foot lifter
3 Foot holder
4 Lever
Attaching the Presser Foot
[1]Turn off the power switch and unplug the
machine.
[2]Place the presser foot so that the pin on the foot
lies just under the groove of the foot holder.
[3]Lower the foot holder to lock the foot into place.
[4]Raise the presser foot lifter to check that the
presser foot is secure.
1
Groove
2 Pin
3 Lever
2 mm
2
1
4
3
3
1
2
2
4
3
1
2
To Next Page
Loading...
