23
• Adjusting the stitch length
Press the stitch length adjustment key to
change the stitch length.
Press “–” to decrease stitch length.
Press “+” to increase stitch length.
The stitch length can be varied from 0.0 to 5.0.
NOTE:
Reverse stitch length cannot be set longer than 4.0.
q
w
• Needle Plate
The seam guides on the needle plate and the hook
cover help you to measure seam allowance. The
numbers on the needle plate indicate the distance
between the center needle position q and the edge
of the fabric w.
q Center needle position
w Edge of the fabric
Distance
(cm)
Number
Distance
(inch)
10 20 30 40 1/2 5/8 3/4 1 1 1/2
1.0 2.0 3.0 4.0
1/2 5/8 3/4 1 1 1/2
— — — —
— — — — —
q
e
[1.0] [2.2] [5.0]
q w e
• Adjusting the needle drop position
The needle drop position can be adjusted for straight
stitch patterns 01–05 (Mode 1 and 2), and 01−03
(Mode 3).
Press the stitch width adjustment key to
change the needle drop position.
Press “+” to move the needle to the right e.
Press “–” to move the needle to the left q.
q Left (0.0)
w Middle (3.5)
e Right (7.0)
The front seam guides e are marked at 1/4˝, 3/8˝ and
5/8˝ from the center needle position q.
e Front seam guides
Janome 4120QDC Sewing Machine Instruction Manual
4120QDC Owners Manual/ User Guide
To Next Page
Loading...
