Janome 5060DC - Threading the Machine

15
q
z
z x
c
v
b n
w
v
b
n
q
c
x
Threading the Machine
Raise the presser foot. Press the needle up/down button
to raise the thread take-up lever to its highest position.
CAUTION:
Turn OFF the power switch before threading the
machine.
• Threading the machine
z x Draw the end of the thread around the upper
thread guide.
c While holding the thread near the spool q, draw
the end of the thread down around the check
spring holder w.
q Spool
w Check spring holder
v Firmly draw the thread up from right to left over the
take-up lever, and down into the take-up lever eye.
b Pass the thread through the lower thread guide.
Slide the thread behind the needle bar thread
guide on the left.
n Thread the needle from front to back, or use the
needle threader.