17
Drawing up the Bobbin Thread
After using auto thread cutting or threading the bobbin
holder, you can start sewing without drawing up the
bobbin thread.
However, you need to draw up the bobbin thread when
sewing gathering stitches etc.
z
Remove the bobbin. Insert the bobbin into the bobbin
holder again and rethread the bobbin holder according
to the instructions on page 14, but leave a 10 cm tail of
bobbin thread as shown.
q Bobbin thread
NOTE:
Do not cut the bobbin thread with the bobbin thread
cutter.
w Bobbin thread cutter
x
Raise the presser foot. Hold the needle thread lightly
with your left hand.
e Needle thread
c
Press the needle up/down button twice to lower and
raise the needle and pick up the bobbin thread.
r Needle up/down button
v
Pull both threads 10 cm under and behind the presser
foot.
z
w
q
q
q
c
v
r
x
e
e
e
To Next Page
Loading...
