Janome 5060DC - Using the Needle Threader

16
q
w
t
r
w
e
z
x
c
v
NOTE:
The needle threader can be used with a #11 to #16
needle or a blue tipped needle. Thread sizes 50 to
90 are recommended.
Needle Threader
CAUTION:
Turn OFF the power switch when using the needle
threader.
z Lower the presser foot. Raise the needle to its
highest position. Pull down the needle threader
knob q as far as it will go. The hook w comes out
through the needle eye from behind.
q Knob
w Hook
x Draw the thread from guide (a) e to guide (b) r
and under the hook w. Draw the thread up along
the right side of guide (b) r and slip the thread in
between guide (b) and the holder plate t.
e Guide (a)
r Guide (b)
t Holder plate
c Raise the knob in the direction of the arrow,
drawing the thread loop through the needle.
v Pull the thread through the needle eye.