Janome 5270QDC - Machine Operating Buttons; Start;Stop, Reverse & Auto-lock Buttons

9
Mode 3
Mode 3
Machine Operating Buttons
q Start/Stop button
Press this button to start or stop the machine.
The machine starts running slowly for the rst few
stitches, and it then runs at the speed set by the speed
control slider.
The machine runs slowly as long as this button is being
pressed.
NOTE:
• The start/stop button cannot be used when the foot
control is connected to the machine.
• The machine will not run and the presser foot mark
will blink if you start the machine with the presser
foot in the up position. Lower the presser foot and
press the start/stop button.
w Reverse button
• When following stitch patterns are selected;
Mode 1 and 2
The machine will sew in reverse as long as the
reverse button is pressed. Release the button to sew
forward.
When the machine is stopped and foot control is
disconnected, the machine will sew in reverse slowly
as long as the reverse button is pressed. Release the
button to stop the machine.
• When any other stitches are selected;
If you press the reverse button when sewing any other
patterns, the machine will immediately sew locking
stitches and automatically stop.
There will be particular functions of the reverse button
when patterns shown above are selected. Refer to
pages 30, 44 and 45 for instructions.
• When following stitch patterns are selected;
Mode 1 and 2
e Auto-lock button
• When following stitch patterns are selected;
Press the auto-lock button to sew a locking stitch
immediately. The machine will automatically stop.
• When any other stitches are selected;
Press the auto-lock button to sew a locking stitch
at the end of current pattern. The machine will
automatically stop.
w
q
e
Mode 1 and 2
09 89 90 91 92 93 94
09 89 90 91 92 93 94