Janome 5270QDC - Needle, Thread Cutter & Twin Needle Buttons

10
r Needle up/down button
Press the needle up/down button to bring the needle up
or down.
NOTE:
The thread cutter button does not function:
- directly after turning on the power.
- when the presser foot is raised.
- after being pressed 3 times in a row.
Use the thread cutter on the face cover if the thread is
#30 or thicker (refer to page 27 ).
tr
i
y
u
t Thread cutter button
Press the thread cutter button to trim the threads after
sewing.
The thread cutter mark will blink y while the machine
cuts the threads.
To trim the threads automatically after sewing, select the
desired stitch pattern, then press and hold the thread
cutter button until the thread cutter mark appears u.
The machine will trim the threads automatically after the
locking stitch then stop when the reverse or auto-lock
button is pressed, or a pattern has the auto-lock stitch
programmed (refer to page 62).
o
i Twin needle button
Press the twin needle button when using a twin needle.
The twin needle mark o will appear when it is activated.
To cancel or nish the twin needle sewing, press the twin
needle button twice.
NOTE:
When the twin needle mark is blinking, all the other
keys and buttons will not be responding. Press the
twin needle button again.
For twin needle sewing, refer to page 60.