Janome 5270QDC - Drawing up the Bobbin Thread

23
c Turn the power switch on.
Press the needle up/down button twice to lower and
raise the needle to pick up the bobbin thread.
r Needle up/down button
v Pull both threads 4˝ to 6˝ (10 to 15 cm) under and
behind the presser foot.
z
x
c
v
r
q
Drawing up the Bobbin Thread
After using auto thread cutting or threading the bobbin
holder, you can start sewing without drawing up the
bobbin thread.
However, you need to draw up the bobbin thread when
sewing gathering stitches etc.
z Remove the bobbin. Insert the bobbin into the bobbin
holder again and rethread the bobbin holder according
to the instructions on page 20, but leave a 10 cm (4˝)
tail of bobbin thread as shown.
q Bobbin thread
NOTE:
Do not cut the bobbin thread with the thread cutter.
w Thread cutter
x Raise the presser foot. Hold the needle thread lightly
with your left hand.
e Needle thread
e
w