62
Programming Auto-thread Cutting
Example: Auto-thread Cutting with Patterns 69 and
78 (mode 3)
z Refer to procedure z to b on “Pattern Combination”
on page 61 to enter the stitch patterns 69 and 78 in
mode 3.
x Press and hold the thread cutter button until the
thread cutter mark appears on the LCD display.
q Thread cutter button
w Thread cutter mark
c Start sewing. A pattern combination series will
be sewn and the machine will trim the threads
automatically after locking stitch.
z x c
q
Programming the Auto-lock Stitch
Example: Pattern 66 (mode 3)
z Select pattern 66 in mode 3.
Press the memory key.
x Press the mode key.
Select pattern 78 in mode 4.
Press the memory key.
c Place the fabric and sew.
The machine will sew a locking stitch q, stitch pattern
66, locking stitch w and stop.
q Initial locking stitch
w End locking stitch
z
x
c
q
w
NOTE:
The locking stitch at the beginning q is
pre-programmed.
w
To Next Page
Loading...
