Janome Continental M17 - GETTING READY TO SEW; Connecting Power & Using Controls

w
q
t
y
r
z
x
w
q
z x
e
11
Adjusting the horizontal position of the thread cutter
switch
z
Loosen the setscrews
q
under the switch.
q
Setscrew
w
Washer
x
ide the sitch to the et or right and fi it at the
desired position by tightening the setscrews with a
screwdriver.
Adjusting the vertical position of the thread cutter
switch
z
Remove the setscrews
q
and washers
w
.
x
Move the switch forward or backward, attach the
switch at the desired position
e
and fi it ith the
setscrews
q
and washers
w
.
NOTE:
• To fi the thread cutter sitch at its oest position
fi the setscres into the hoe
r
, and then holes
t
.
• Tighten the setscrews securely.
• Peel off the backing paper from the rubber sole
y
and attach it to the bottom of the thread cutter switch
as shown.