Janome Continental M17 - Thread Cutter Switch; Preparation for Thread Cutter Switch

q
e
w
z
x
c
v
x
v
q
t
r
w
y
u
e
z
1515
Preparation for thread cutter switch
z
Remove the cable tie
q
from the cable.
x
If you wish to use the thread cutter switch, you need
to connect it with the foot control.
Insert the pin connector
w
into the jac
e
on the foot
control.
c
Turn the foot control upside down.
Open the base cover of the foot control.
v
Draw out the cable from the foot control.
Thread Cutter Switch
If you wish to use the thread cutter switch, pull out the
cord from the foot control and insert the pin connector
into the jac on the machine
z
First make sure the power switch
q
is off.
x
Insert the machine plug
w
of the power supply cable
into the machine socket
e
.
c
Draw out the cord from the foot control and insert the
pin connector
r
into the jac
t
on the machine.
v
Insert the power supply plug
y
into the wall outlet
u
,
and turn the power switch
q
on.
q
Power switch
w
Machine plug
e
Machine socket
r
Pin connector
t
Jack
y
Power supply plug
u
Wall outlet