Janome Continental M17 - DECORATIVE STITCHES Overview; Stitch Categories and Usage

z
x
c
r
r
e
e
q
w
0.9 cm
r
74
B15 Darning
z
Attach automatic buttonhole foot R and pull the button
holder all the way out.
Place the fabric under the foot, and lower the needle
at the starting point. Then lower the foot.
q
Button holder
w
Starting point
To adjust the evenness of darning stitches
You can correct unevenness of darning stitches by
turning the stitch idth adjusting dia or pressing the 
or “+” key.
If the left corner is lower than the right side, turn the stitch
idth adjusting dia countercocise or press the  e
to correct it.
If the right corner is lower than the left side, turn the stitch
idth adjusting dia cocise or press the  e to
correct it.
x
tart the machine and se to the reuired ength then
press the reverse button. This sets the darning length.
Continue sewing until the machine stops automatically.
e
Reverse button
r
euired ength
c
e another aer o darning oer the first aer at a
right angle to it.
To sew the same size darning
hen finished seing a confirmation message i
appear.
Simply start the machine to sew another layer of darning
stitches in the same size.
To sew the next layer of darning stitches in a different
size, press the X key.
To sew shorter darning
e the first ine to the desired ength and stop the
machine.
Press the reverse button and start the machine again.
The machine will sew the rest of the darning and stop
automatically.
NOTE:
The maimum darning ength is  cm  and the
maimum idth is  cm 