Janome Continental M17 - GETTING READY to SEW Connecting the Power Supply

e
w
q
z
c
r
t
x
c
13
Operating Instructions:
The symbol “O” on the switch indicates the “off” position
of the switch.
Foot controller Model 21390 is for use with sewing
machine Continental M17.
For the U.S.A. and Canada only
Polarized plug (one blade wider than the other):
To reduce the risk of electric shock, this plug is intended
to fit in a poaried outet on one a  it does not fit
u in the outet reerse the pug  it sti does not fit
contact a uaified eectrician to insta the proper outet
Do not modify the plug in any way.
GETTING READY TO SEW
Connecting the Power Supply
z
First make sure the power switch
q
is off.
x
Insert the machine plug
w
of the power supply cable
into the machine socket
e
.
c
Insert the power supply plug
r
into the wall outlet
t
,
and turn the power switch
q
on.
q
Power switch
w
Machine plug
e
Machine socket
r
Power supply plug
t
Wall outlet
NOTE:
• Make sure to use the power supply cable that came
with the machine.
• If you turn off the power switch, wait for 5 seconds
before turning it on again.
WARNING:
• While in operation, always keep your eyes on the
sewing area, and do not touch any moving parts
such as the thread take-up lever, handwheel or
needle.
• Always turn off the power switch and unplug the
machine from the power supply:
- when leaving the machine unattended.
- when cleaning the machine.
• o not pace an ojects on the oot contro