Janome Continental M17 - Foot Control and Thread Cutter Switch; Adjusting the Thread Cutter Switch Position

e
y
w
w
e
q
q
w
t
q
r
q
r
e
q
z
x
c
10
Adjusting the Thread Cutter Switch Position
Placing the thread cutter switch to the left.
The thread cutter sitch position can e adjusted or our
convenience.
If you wish to attach the thread cutter switch to the left
side of the foot control, follow the procedure below.
z
Remove the setscrews A
q
, B
w
and washers
e
with
a Phillips head screwdriver.
q
Setscrew A
w
Setscrew B
e
Washer
Foot Control and Thread Cutter Switch
To attach the foot control
q
and the thread cutter
switch
w
to the base plate
e
, tighten setscrews
r
, and
setscrews
t
with washers
y
as shown.
q
Foot control
w
Thread cutter switch
e
Base plate
r
Setscrew A
t
Setscrew B
y
Washer
NOTE:
Phillips head screwdriver is not included with this
machine.
x
Turn the base plate 180 degrees.
c
Attach the foot control and thread cutter switch
with the setscrews and the washers
e
. Tighten the
setscrews A
q
and B
w
. Be sure that the cable is not
caught between the foot control and the base plate.