Janome Continental M17 - Troubleshooting; Problem Resolution and Warning Signals

z
x
c
v
q
179
Replacing the Coin Cell Battery for the Internal
Clock
If the clock on the right touch screen always indicates
“0:00” when turning the power switch on, replace the coin
cell battery in the sewing machine.
z
Remove the battery cover
q
with a screwdriver.
q
Battery cover
x
Remove the coin cell battery.
c
Install the “CR2032” battery with the “+” mark facing
up.
WARNING:
• Battery may explode if mistreated.
o not recharge disasseme or dispose o  fire
• Turn off the power switch before replacing the
battery.
• Replace the battery with “CR2032” type only.
Use o another ma present a ris o fire or
explosion.
• Chemical Burn Hazard. Keep the battery away from
children.
• The batteries must be disposed of properly.
v
Attach the battery cover.
Set the clock again after replacing the battery (refer to
page 166).