Janome DKS100 SE - Thread and Bobbin Setup; Setting the Spool of Thread; Bobbin Winding Procedure

13
SettingtheSpoolofThread
Horizontalspoolpin
Lift up the spool pin. Place a spool of thread on the spool
pin.
Attach the large spool holder, and press it firmly against
the spool of thread so that the spool rests on the
supporter.
q Spool pin
w Spool of thread
e Large spool holder
r Supporter
The small spool holder is used with narrow or small
spools of thread.
t Small spool holder
q
w
e
BobbinWinding
Removingthebobbin
Gently slide the hook cover release button to the right
and remove the hook cover plate.
Lift out the bobbin.
q Hook cover release button
w Hook cover plate
e Bobbin
NOTE:
q
w
e
r
t
y
u
i
Extraspoolpin
The extra spool pin is for twin needle sewing, or winding
bobbins without unthreading the machine.
Insert the extra spool pin into the hole.
The extra spool pin should point to the bobbin winder
tension disk.
y Extra spool pin
u Hole for additional spool pin
i Bobbin winder tension disk
20.6 mm
11.8 mm
Use the Janome plastic bobbins. Using
other bobbins such as prewound paper
bobbins, may cause stitching problems or
damage to the bobbin case.