Janome DKS100 SE - Edge Finishing Stitches; Overcasting and Overedge Stitches; Multiple Zigzag Stitch (Pattern 08)

26
4
4
OveredgeStitch
q Stitch pattern: 09
w Thread tension dial: 3 to 7
e Presser foot: Overedge foot C
This stitch is used to seam and overcast fabric edges at
one time.
Use this stitch when you do not need to open seams flat.
Sew while guiding the fabric edges along the guide on
the foot.
r Guide
NOTE:
The stitch width cannot be adjusted to less than 4.5 to
prevent the needle from hitting the wires on the foot.
q w
e
q w
e
MultipleZigzagStitch
q Stitch pattern: 08
w Thread tension dial: 3 to 7
e Presser foot: Zigzag foot A
This stitch is used to finish a raw edge of synthetics and
other stretch fabrics that tend to pucker.
Sew along the fabric edge leaving an adequate seam
allowance.
After sewing, trim off the seam allowance closer to the
stitches.
This stitch is also excellent for darning and mending
tears.
r
4
OvercastingwithZigzagStitch
q Stitch pattern: 07
w Thread tension dial: 3 to 7
e Presser foot: Overedge foot C
Place the fabric edge next to the guide on the foot and
sew while guiding the fabric along the guide.
r Guide
CAUTION:
When using an overedge foot, make sure to set the
stitch width at 4.5 or wider, otherwise the needle may
hit the wires on the foot.
q w
e
r