Janome DKS100 SE - Adjusting Buttonhole Width and Density; Round-end and Keyhole Buttonholes

32
Adjustingthewidthanddensityforbuttonholes
•Adjustingthebuttonholewidth
Press the “+” sign on the stitch width adjusting key to
increase the buttonhole width.
Press the “–” sign on the stitch width adjusting key to
decrease the buttonhole width.
q Stitch width adjusting key
NOTE:
The buttonhole width can be adjusted from 2.5 to 7.0.
•Adjustingthestitchdensity
Press the “+” sign on the stitch length adjusting key to
increase the stitch density.
Press the “–” sign on the stitch length adjusting key to
decrease the stitch density.
w Stitch length adjusting key
NOTE:
The buttonhole width can be adjusted from 0.3 to 0.8.
q
w
KeyholeButtonhole
q Stitch pattern: 13
w Thread tension dial: 1 to 5
e Presser foot: Automatic buttonhole foot R
Sewing procedure is the same as square buttonhole.
The buttonhole width can be varied from 5.5 to 7.0.
The stitch density can be varied from 0.3 to 0.8.
Use the seam ripper and an eyelet punch to open the
buttonhole.
q Eyelet punch (not provided with the machine)
Round-endandFineFabricButtonholes
q Stitch pattern: 12, 15
w Thread tension dial: 1 to 5
e Presser foot: Automatic buttonhole foot R
Sewing procedure is the same as square buttonhole.
The buttonhole width can be varied from 2.5 to 5.5.
The stitch density can be varied from 0.3 to 0.8.
4
4
q
w
e
q
w
e
q
StretchButtonhole
q Stitch pattern: 14
w Thread tension dial: 1 to 5
e Presser foot: Automatic buttonhole foot R
Sewing procedure is the same as square buttonhole.
The buttonhole width can be varied from 2.5 to 7.0.
The stitch density can be varied from 0.5 to 1.0.
The sewing steps are as shown.
4
q
w
e