Janome DKS100 SE - Fringing and Drawn Work Stitches

46
Fringing
q Stitch Pattern: 36
w Thread tension dial: 3 to 6
e Presser foot: Satin stitch foot F
4
q
w
e
Fringing adds a special touch on table linens and shawls.
Choose a firm, woven fabric like linen where threads can
be removed easily.
Carefully cut the fabric on the grain. Remove a single
strand of yarn or thread where the fringing is to begin.
Sew down the left side so the right hand stitches fall in
the open space.
DrawnWork
q Stitch pattern: 36
w Thread tension dial: 3 to 6
e Presser foot: Satin stitch foot F
Drawn work uses the same method as fringing. Choose
a firm, woven fabric like linen where threads can be
removed easily.
z Carefully cut the fabric on the grain. Determine the
width of the drawn work and remove one strand of
yarn or fabric thread at each end.
z
x
c
x Sew down the left side, guiding the fabric so the right
hand stitches fall in open space. After finishing the left
side, turn the fabric around 180°. Sew down the other
side.
c Remove the yarn or fabric threads between the
stitching.
4
q
w
e
Remove all excess yarn located to the right of the
stitching and create a fringe.