Janome DKS100 SE - Tacking Stitch (Pattern 18)

38
START
STOP
Tacking is used to reinforce pockets, crotches and belt
carriers where extra strength is needed.
•Startsewing
Start the machine and sew until the machine stops
automatically. The machine will sew a tacking 1.5 cm
(5/8˝ ) long.
q 1.5 cm (5/8˝)
NOTE:
The machine will cut the threads at the end of sewing
automatically if the thread cutter icon is indicated on
the LCD display (refer to page 20).
•Sewingashortertack
To sew a tack shorter than 1.5 cm (5/8˝), first stop the
machine after sewing the required length, then press the
reverse button.
The tack length has been determined.
Start the machine again and continue sewing until the
machine stops automatically.
w Required length
e Reverse button
r Tack length
•Sewingasame-sizetacking
Simply start the machine to sew another tack at the same
size.
4
q
w
e
Tacking
q Stitch pattern: 18
w Thread tension dial: 3 to 6
e Presser foot: Satin stitch foot F
q
w
e
r