Janome DKS100 SE - Twin Needle Pattern Selection and Sewing

52
The LCD display shows a twin needle icon and the
maximum permissible stitch width is restricted to 3.0 mm.
The needle drop position of straight stitches is restricted
to between 2.0 and 5.0.
w Twin needle icon
e Maximum width (3.0)
NOTE:
•Ifyoupressthetwinneedlekey,awarningsignal
sounds and the twin needle icon blinks when
a pattern not suitable for twin needle sewing is
selected.
•Whenthetwinneedleiconappearsonthescreen,
the patterns not suitable for twin needle sewing
cannot be selected.
•Ifyoupressthetwinneedlekeyagain,theLCD
display shows only the blinking twin needle icon
and all the keys and buttons except for the twin
needle key will be deactivated. Press the twin
needle key again to change the setting to single
needle sewing.
Sewing
Sew at a medium speed.
When changing the sewing direction, raise the needle
from the fabric.
NOTE:
Use the thread cutter on the face cover when sewing
with the twin needle.
After twin needle sewing is finished, turn off the machine
and replace the needle.
Selectingthepatterns
Select the desired pattern suitable for twin needle sewing.
Press the twin needle key.
q Twin needle key
q
w
e