9
z
c
x
z
x
c
v
b
v
b
Threading the Machine
Raise the take-up lever to its highest position by
turning the handwheel toward you.
Raise the presser foot.
Place a spool on the spool pin as shown, with
thread coming from back of the spool.
z
Draw the thread into thread guide using both
hands.
x
While holding the thread near spool, draw
thread down into the tension area and then
around the check spring holder.
c
Firmly draw the thread up and through the
take–up lever from right to left.
v
Then draw the thread down and slip it into
needle bar thread guide on the left.
b
Thread the needle eye from front to back.
NOTE:
You may want to cut the thread end with
sharp scissors for easier needle
threading.
To Next Page
Loading...
