4
Operating Instructions (for the U.S.A and
Canada only)
This appliance has a polarized plug (one blade
wider than the other). To reduce the risk of an
electric shock, this plug is intended to fit in a
polarized outlet only one way. If the plug does
not fit in the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician to install the
proper outlet. Do not modify the plug in any way.
Foot Controller Model KD-1902, YC-482J-EC or
TJC-150 is used with this machine.
SECTION II. GETTING READY TO SEW
Connecting the Machine to the Power Supply
z Turn off the power switch.
x Insert the machine plug into the machine
socket.
c Insert the power supply plug into the outlet.
v Turn on the power switch to turn on the power
and sewing light.
q Power supply plug
w Power switch
e Outlet
r Machine socket
t Machine plug
Controlling Sewing Speed
Sewing speed can be varied by the foot control.
The harder you press on the foot control, the faster
the machine runs.
CAUTION:
Before connecting the power cord, make
sure the voltage and frequency shown on the
machine conform to your electrical power.
NOTE:
While in operation, always keep your eyes
on the sewing area, and do not touch any
moving parts such as the thread take-up lever,
handwheel or needle.
Always turn off the power switch and unplug
from the power supply:
– when leaving the machine unattended.
– when attaching or removing parts.
– when clearning the machine.
Do not place anything on the foot control,
otherwise the machine will run inadvertently.
r
t
w
q e
To Next Page
Loading...
Need help?
General
