Janome Hello kitty - Presser Foot Lifter and Changing

5
Presser Foot Lifter
The presser foot lifter raises and lowers your
presser foot.
You can raise it about 0.6 cm (1/4˝) higher than
the normal up position for easy removal of the
presser foot or to help you to place heavy fabric
under the foot.
q Lowest position
w Normal up position
e Highest position
e
w
q
To Attach and Remove the Foot Holder
q Thumb screw
w Foot holder
e Presser bar
•Toremove
Remove the thumb screw q by turning it
counterclockwise with a screwdriver.
•Toattach
Match the hole in the foot holder w with the
threaded hole in the presser bar e. Fit the
thumb screw q into the hole. Tighten the screw
q by turning it clockwise with screwdriver.
q
q
w
e
Changing Presser Foot
q Presser foot
w Groove
e Pin
q
e
w
•Toremove
Turn the handwheel toward you to raise the
needle bar to its highest position.
Raise the presser foot.
Push the toe of the presser foot q to snap it off
the foot holder.
•Toattach
Place the presser foot so that the pin e on the
foot lines up directly below the groove
w of the
foot holder. Lower the foot holder to lock the foot
in place.
CAUTION:
When attaching or removing presser foot, turn
OFF the power switch.