Janome Hello kitty - Seam Guide Lines; Turning a Square Corner; Zigzag Stitching

14
q
q Center needle position
w Guide lines
e Numbers
Seam Guide Lines
The numbers on the needle plate indicate the
distance between the center needle position and
the guideline.
The numbers in front are centimeters.
The numbers in back are fractions of an inch.
Number 15 20 4/8 5/8 6/8
Distance (cm) 1.5 2.0 1.3 1.6 1.9
Turning a Square Corner
Toturnasquarecorner5/8”(1.6cm)fromthe
fabric edge.
Stop stitching and lower the needle by turning the
handwheel counterclockwise.
Raise the presser foot and turn the fabric to line
theedgewiththe5/8”(1.6cm)seamguide.
Lower the presser foot and begin stitching in the
new direction.
Line up the fabric edge facing you with the
cornering guide shown.
q
Cornering guide
q Pattern selector: C
w Presser foot: Zigzag foot
e Thread tension: 2–5
r Stitch length: 0.5–4
Zigzag Stitching
Simple zigzag stitching is widely used for
overcasting, sewing on buttons, etc.
Turn the pattern selector between the zigzag
stitch (C) and straight stitch (left position) (B) to
adjust the stitch width.
q
w
e
w e
q
r