FOR YOUR SAFETY
Keep the emergency stop switch within reach of an operator while
teaching and running the machine.
Failure to do so may cause danger since the machine cannot be stopped
immediately and safely.
Use the machine in an environment between 0 to 40 degrees
centigrade with a humidity of 20 to 95 percent without condensation.
Use outside tease conditions may result in malfunction.
IP Protection Rating is “IP40.”
Warnings
Turn off the unit before inserting and removing cables.
Failure to do so may result in electric shock, fire, or malfunction of the unit.
IP Protection Rating is “IP40.”
Confirm that the unit is properly grounded.
Power supply earth should be connected complying with Type D grounding.
(under 100 Ω of resistance.)
Insufficient grounding can cause electric shock, fire or malfunction.
Do not attempt to disassemble or modify the machine.
Disassembly or modification may cause electric shock, fire or malfunction.
Do not use the unit near inflammable or corrosive gas.
If leaked gas accumulates around the unit, it can cause fire.
IP Protection Rating is IP40.
Be sure to use within the voltage range indicated on the unit.
Failure to do so may cause electric shock or fire.
Plug the power cord into the wall outlet firmly.
Incomplete insertion into the wall outlet heats the plug and can cause fire.
Check that the plug is not covered with dust.
Be sure to shut off the power supply before connecting the power cord
Setup Electro Press JP Series 4 iv
To Next Page
Loading...
