FOR YOUR SAFETY
The installation mount should be steel. For the stand-alone type, it
should be able to support the machine’s weight. For the head and unit
types, it is able to support the machine’s weight and pressing capacity.
Use the machine in an environment that is not dusty or damp.
Dust and dampness may cause failure or malfunction.
Place the control box on a flat surface more than 80 cm above the floor so
that it is easier to operate it.
Attach an eyebolt and use a crane or other equipment to transport the
machine.
Failure to do so may result in malfunction or defect.
Do not bump or jar the machine while it is being transported or
installed.
This can cause defects.
Use the machine in an environment where it is not exposed to
direct sunlight.
Direct sunlight may cause malfunction or defect.
Be sure to confirm that jigs such as the electric screwdriver unit, etc.
are properly connected.
Failure to do so may result in injury or defect.
Be sure to check the wiring to the main unit.
Improper wiring may cause malfunction or defect.
Be sure to shut off the power supply before plugging the power cord.
Use the machine in an environment where no electric noise is
To Next Page
Loading...
