8
• Inserting the Bobbin
z Place the bobbin in the bobbin holder with the thread
running counterclockwise.
x Guide the thread into notch A on the front side of the
bobbin holder.
Draw the thread to the left, sliding it between the
tension spring blade.
Continue to draw the thread lightly until the thread
slips into notch B.
Pull out about 15 cm (6") of thread.
c Attach the hook cover plate.
Check the threading by referring to the chart shown on
the hook cover plate.
q
Bobbin thread
B
z
x
c
A
q
To Next Page
Loading...
