27
Sew a Button
q Selected stitch
w F: Satin stitch foot
* Set the stitch width in accordance with the position
of the holes on the button.
z Match the button holes to the horizontal slot on the
presser foot.
x Lower the foot to hold the button in place.
c Turn the balance wheel by hand until the needle point
is just above the button.
v Press the stitch width key “ + ” or “ – ” so the needle
will enter the left hole of the button.
b Turn the balance wheel so the needle will enter the
right hole of the button. Readjust the stitch width if
necessary.
n Stitch several times.
m After you finish sewing, cut the thread but leave 10 to
15 cm (4" – 6" ) of thread at the button.
, Draw the thread to the reverse side of the fabric and
knot the threads.
e
Needle thread
r Bobbin thread
t Fabric
07
A
37
q
w
zxcv
b
nm
,
e
t
r
To Next Page
Loading...
