22
............
............
............
x
c
v
b
q
e
r
t
y
u
Sensor Buttonhole, cont’d
x Pull the button holder to the back, and place the
button in it. Push it together tightly on the button.
q
Button holder
If the button is extremely thick, make a test buttonhole.
If it is difficult to fit the button through the test
buttonhole, engthen the size by pulling the button holder
on the back to increase length.
w
Gap
c Pull the buttonhole lever downward as far as it will go.
e
Buttonhole lever
v Draw both threads to the left under the foot. Insert the
garment under the foot, and lower the needle at the
starting point.
Then lower the automatic buttonhole foot.
r
Mark
t Needle thread
y Bobbin thread
u Starting point
b Depress the foot control until the machine stops by
itself .
* The buttonhole will be automatically sewn: the
front bartack and left row first, then the right row
and back bartack.
The machine will stop automatically.
Before you sew buttonholes on the actual garment,
make some practice buttonholes.
To sew another buttonhole or to start from the
beginning of the buttonhole press the key BH1( ),
then depress the foot control.
1STEP
STEP 2
STEP 3
RAISE
FOOT
PRESS BH1
KEY
w
R
To Next Page
Loading...
