18
• Inserting the bobbin
[1]
Place the bobbin in the bobbin holder with the thread
running off counterclockwise.
1 End of thread
[2] Guide the thread into the notch on the front side
of the bobbin holder.
2 Notch
[3] Continue to draw the thread lightly. The thread slips
into notch .
Pull out about 15 cm (6”) of thread.
3 Notch
[4] Attach the hook cover plate.
Check the threading by referring to the chart shown
on the hook cover plate.
4 Threading chart
[1]
[2]
[3]
[4]
1
2
3
4
B
A
A
A
To Next Page
Loading...
