Janome MEMORY CRAFT 4800 - Needle threader

19
Threading the Machine
• Threading the machine
* Raise the presser foot lever.
* Turn the power switch “ON”, press the needle
Up/down button twice to raise the needle, then turn
the power switch “OFF”.
1 Presser bar lifter
2 Needle Up/down button
[1] Raise the presser foot lifter.
Draw the thread from the spool and thread around
the upper thread guide “A” and “B”.
3 Thread guide “A”.
4 Thread guide “B”
[2] Then, down around the check spring holder.
5 Thread guide plate
[3] Turn the handwheel toward you to raise the thread
take-up lever.
Firmly draw the thread from right to left over the
take-up lever and down into the take-up lever eye.
6 Thread take-up lever
[4] Then, down through the lower thread guide.
7 Thread guide “D”
[5] Slide the thread behind the needle bar thread guide
on the left.
8 Needle bar thread guide
* Use the automatic needle threader (see page 20).
[1]
[3]
[5]
[2][4]
[1]
[2]
[3]
[4]
[5]
1
2
4
3
5
6
7
8
“A”
“B”
“D”