Janome memory craft 4900 - Knit Stitch; Double Overedge Stitch; Overlock Stitch

www.toews.com
36
12
13
Knit stitch
Machine settings
q Pattern: 11 (mode 2)
w Presser foot: Zigzag foot A
e Thread tension: AUTO
This stitch is recommended for sewing such fabrics as
synthetic knits and stretch velour, as it provides the greatest
amount of elasticity and strength.
Sew along the fabric edge leaving an adequate seam
allowance.
After sewing, trim the seam allowance close to the stitches.
Double overedge stitch
Machine settings
q Pattern: 12 (mode 2)
w Presser foot: Overedge foot C
e Thread tension: AUTO
This is an excellent stitch for fabrics that tend to ravel
extensively such as linens and gabardines.
Two rows of zigzag stitches are simultaneously sewn over
the edge to insure that fabric will not ravel.
Place the fabric edge next to the guide of the foot and then
sew.
q Fabric edge
w Guide
CAUTION:
When you use the overedge foot C, you must set the zigzag
width at 5.0 or wider to prevent the needle from hitting the
wires on the foot.
Overlock stitch
Machine settings
q Pattern: 13 (mode 2)
w Presser foot: Overcasting foot M
e Thread tension: 6–8
This stitch finishes the edges of fabric similar to a commer-
cial overlocking machine for a professional look.
Place the fabric edge next to the guide of the foot and then
sew.
CAUTION:
When you use the overcasting foot M, you must set the
zigzag width at 5.0 or wider to prevent the needle from
hitting the wires on the foot.
q Edge of Fabrics
w Guide
e Wires on Foot
qw
e
11
qw
e
qw
e
w
q
q
w
e
Janome Memory Craft 4900 Instruction Manual
Janome Sewing Machine 4900
www.toews.com
MC4900 Owners Manual/ User Guide